End
Point - the end point of the timeline (in hh:mm:ss.ms format).
Relative
to Start - if enabled, the end point will be calculated relative
to the start point.
End
of File - if enabled, the end point of the timeline will be set
to the last frame of a produced video file.
Relative to EOF - if enabled, the end point will be calculated
relative to the end of file.
Cycle
This section includes properties concerned
with the dynamic effect's cycle.
Mode
- the cycle mode. This parameter can take one of the following values:
All Timeline - if
selected, one cycle of the dynamic effect will take the whole timeline.
Custom Duration -
if selected, one cycle of the dynamic effect will take the specified time.
In this case the following parameters become available:
Duration
- the time taken by one cycle of the dynamic effect (in hh:mm:ss.ms format,
where hh - hours, mm - minutes, ss - seconds, ms - milliseconds).
Delay
- the time for which the launch of every next cycle will be delayed.
All other properties of the Key Point dynamic
effect correspond to the properties of the affected watermark. By changing
them you can make the watermark look different relative to its initial
appearance.
Read
more about how to apply a dynamic effect to a watermark and access the
effect's properties.